More iPad Problems

[ray]

I’m uploading my last log. I subsequently set Selective Transfer instead of Automatic or Selective Share. Relayed transfer is not enabled. I also changed the direct mode wait times to 2 & 1.
The reason I setup a separate network is because of the guidance from the eyefi support site.
“The Apple Airport Extreme by default is set to a wireless security setting called WEP (Transitional Security Network), which is not compatible with the Eye-Fi Card and is also not the standard implementation of WEP. To properly configure your Airport Extreme, please proceed as follows:
Warning: This will reconfigure the security settings for your wireless network. You will need to reconfigure all of the computers on your network to reconnect using the new security settings.
Etc.”
I also have problems with the eyefi helper crashing.
Thanks

[ray]

Here is the card data. Thanks

[TheBrew]

[00:14] Connecting to WLAN "EyeFi Home"...
..
[00:18] Received DHCP address 172.16.42.5.
[00:18] Fetching card settings from server...
[00:19] Fetched transfer mode 0x000 and geo enable 0 from server
..
[01:15] Scan complete
[01:26] Starting scan of media directories...
[01:26] Done scanning for new media (detected 10 MB in all media). Uploads pending.
[01:26] All uploads done, disconnecting from network.

Looks like the card is set up to not transfer any photos. So it never starts probing for receivers. Could you try turning on the Automatic transfer again and make sure that it's configured to transfer photos?

[ray]

For some reason it was not set to automatic. It is now, but still no iPad photos. Log after automatic was reset attached. Thanks

[MadDawgJ]

The problem is that the card is currently not set to transfer any files. Run through the ShutterSnitch setup steps again, viewtopic.php?f=12&t=63, and then re-add the network to the card. (Re-adding the network ensures that the card checks for it's most current settings). Then take five pictures and wait five minutes to see if they transfer. If they do not transfer then please grab another card log so we can see what is going on.

[TheBrew]

It still says it's in "none" mode.

Could you try going through the "Options" -> "Set up Eye-Fi Access" step again in ShutterSnitch and make sure that the on/off button for the card is turned on. That'll ask the Eye-Fi server to update your card (so be sure that you have Internet access via the "EyeFi Home" network.

Then enter a collection and turn on the camera. ..and wait, let's say, 5 minutes. If nothing happens, get the log again and send that.

Update: What MadDawgJ said.. :)

[ray]

Update. I re-installed the iPad EyeFi app. It works??? I will remove the EyeFi app again and try your suggestions. Thanks.

[ray]

It works! Many thanks. Now that I understand the card and the app, I may be able to help some other folks. Thanks again.

[TheBrew]

Good to hear!